crwdns2915892:0crwdne2915892:0
This guide shows how to remove and replace the inverter module for the Honda EU3000IS1AWK 3000 watt generator.
You will need a long shaft (at least 5 inches) Phillips screwdriver in order to complete this guide.
crwdns2942213:0crwdne2942213:0
-
-
Use a large flathead screwdriver to unlock the maintenance cover.
-
Open the maintenance cover.
-
-
-
Use a Phillips screwdriver to remove the screw securing the spark plug cover.
-
Remove the spark plug cover.
-
-
-
Grab the plastic housing at the end of the spark plug wire.
-
Pull firmly to disconnect the wire from the spark plug.
-
-
-
Turn the fuel valve to the cutoff position.
-
-
-
Use a 10 mm socket to remove the four capped nuts securing the front cover.
-
Remove the front cover.
-
-
-
Use an 8 mm socket to disconnect the battery wires from the battery terminals.
-
Disconnect the black negative cable first to prevent the risk of shorting the battery.
-
-
-
Unclip the battery strap from the lower plate.
-
-
-
-
Use a 10 mm socket to remove the four capped nuts securing the lower plate.
-
Remove the lower plate.
-
-
-
Insert a flathead screwdriver into the top of the brown fuse clip in order to release the fuse holder.
-
Detach the fuse holder from the brown clip.
-
-
-
Use pliers to lift and disconnect the choke cable from the choke stay.
-
-
-
Use a long shaft Phillips screwdriver to remove the deeply recessed screw securing the fuel cutoff switch.
-
-
-
Use a 10 mm socket to remove the four bolts securing the control panel.
-
-
-
Carefully tilt the control panel downwards.
-
-
-
Remove the following bolts securing the inverter:
-
One 8 mm ground bolt
-
Three 10 mm bolts (one behind the control panel)
-
-
-
Reach behind the inverter along the edges and disconnect the six connectors from the back of the inverter.
-
The third image shows the locations of all six sockets on the inverter.
-
-
-
Use a screwdriver to push the metal collar out of the center of the rubber mount.
-
-
-
Squeeze the mount and remove it from the inverter.
-
Repeat the procedure with the remaining mounts and transfer them to the replacement inverter.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
