crwdns2915892:0crwdne2915892:0
This guide shows how to remove and replace the carburetor for the Honda EU3000IS1AWK 3000 watt generator.
The guide lists all the gaskets encountered during the repair. You should replace any gasket that looks damaged or worn.
crwdns2942213:0crwdne2942213:0
-
-
Use a large flathead screwdriver to unlock the maintenance cover.
-
Open the maintenance cover.
-
-
-
Use a Phillips screwdriver to remove the screw securing the spark plug cover.
-
Remove the spark plug cover.
-
-
-
Grab the plastic housing at the end of the spark plug wire.
-
Pull firmly to disconnect the wire from the spark plug.
-
-
-
Turn the fuel valve to the cutoff position.
-
-
-
Unlatch the four clips securing the air cleaner cover.
-
Remove the air cleaner cover.
-
-
-
Remove the air cleaner filter from the housing.
-
-
-
Pull and disconnect the breather tube from the top corner of the air cleaner housing.
-
-
-
Pull and disconnect the lower tube from the bottom corner of the air cleaner housing.
-
-
-
-
Use a 10 mm socket to remove the three fasteners securing the air cleaner housing:
-
Two 10 mm nuts
-
One 10 mm bolt
-
-
-
Pull the housing out slightly from its recess.
-
-
-
Use a flathead screwdriver to pry and unclip the tube from the air cleaner housing.
-
-
-
Place a container below the carburetor drain tube to catch the excess fuel.
-
The carburetor drain screw is located at the bottom of the carburetor.
-
Use a flathead screwdriver to loosen the brass fuel drain screw until fuel begins to drain out of the carburetor.
-
Once you drain the fuel bowl, re-tighten the fuel drain screw.
-
-
-
Remove the carburetor spacer gasket.
-
-
-
Slide the choke stay off the carburetor mounting bolts and move it out of the way.
-
-
-
Slide the carburetor off the mounting bolts.
-
-
-
Disconnect the throttle control connector from the top of the carburetor.
-
Unwrap the throttle control wires from the carburetor.
-
-
-
Use pliers to squeeze and loosen the hose clamp securing the carburetor fuel hose.
-
Pull and disconnect the fuel hose from the carburetor.
-
-
-
If your replacement carburetor did not come with hose clips, transfer the existing clips onto the new carburetor.
-
-
-
If the carburetor gasket is worn, remove and replace it.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0
