crwdns2931653:01crwdne2931653:0 Housing

• Ensure the device is unplugged from the wall outlet.
crwdns2913378:0crwdne2913378:0
crwdns2934285:0crwdne2934285:0
crwdns2934285:0crwdne2934285:0
crwdns2917038:0crwdne2917038:0
1024
crwdns2891542:0crwdne2891542:0 crwdns2934287:0crwdne2934287:0
crwdns2931653:02crwdne2931653:0

• Remove eight 12-mm Phillips #2 screws from the back cover.
crwdns2913378:0crwdne2913378:0
crwdns2934285:0crwdne2934285:0
crwdns2934285:0crwdne2934285:0
crwdns2917038:0crwdne2917038:0
1024
crwdns2891542:0crwdne2891542:0 crwdns2934287:0crwdne2934287:0
crwdns2931653:03crwdne2931653:0
• Turn heater over so the controls are facing up.
• Lift the front housing away from the back of the fan and slowly fold the front housing back down to the floor.
• Internal wires are connected to both halves of the housing. Be careful when separating the housing.
crwdns2913378:0crwdne2913378:0
crwdns2934285:0crwdne2934285:0
crwdns2934285:0crwdne2934285:0
crwdns2917038:0crwdne2917038:0
1024
crwdns2891542:0crwdne2891542:0 crwdns2934287:0crwdne2934287:0
crwdns2931653:04crwdne2931653:0 Circuit Board Removal
• Remove four 12mm Phillips #2 screws from the circuit board.
crwdns2913378:0crwdne2913378:0
crwdns2934285:0crwdne2934285:0
crwdns2934285:0crwdne2934285:0
crwdns2917038:0crwdne2917038:0
1024
crwdns2891542:0crwdne2891542:0 crwdns2934287:0crwdne2934287:0

crwdns2942557:0crwdne2942557:0

crwdns2942955:0crwdne2942955:0

<iframe id="dozuki-embed-74325" src="https://ts.ifixit.com/Guide/embed/74325/full" width="800" allowfullscreen frameborder="0"></iframe> <script>window.addEventListener("message",function(a){var b=document.getElementById("dozuki-embed-74325"),c=a.data[0],d=a.data[1];switch(c){case"setHeight":b.style.height=d+"px"}},!1);</script> <iframe src="https://ts.ifixit.com/Guide/embed/74325" width="800" height="584" allowfullscreen frameborder="0"></iframe>

crwdns2852917:0crwdne2852917:0