crwdns2915892:0crwdne2915892:0
The top panel houses and protects the projector's sensitive internal components. If there is any damage to the top case, it may need to be replaced. Removing the top panel is also necessary to replace most of the internal components for the Hitachi CP-X2010N.
Before removing the top panel, ensure the device is powered off and unplugged. Also make sure that the projector has cooled off if it has recently been used as it could become warm after prolonged use.
crwdns2942213:0crwdne2942213:0
-
-
-
Flip the projector upside down to expose the screws on the underside.
crwdns2952109:0crwdne2952109:0
-
-
-
Use a Phillips #2 screwdriver to remove eight black 14 mm screws holding the top panel to the main projector body.
-
-
-
-
Flip projector right side up and orient it so you are facing the rear panel.
-
-
-
Use a Phillips #2 screwdriver to remove two silver 22 mm long screws.
-
Use a Phillips #2 screwdriver to remove the short silver 10 mm screw.
-
-
-
Carefully lift the top panel from the body of the projector, making sure it doesn't catch on anything.
-
Remove the panel from the body of the projector.
-
-
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0
crwdns2935287:0crwdne2935287:0
Austin Community College, Team 9-2, Watkins Fall 2022 crwdns2935289:0Austin Community College, Team 9-2, Watkins Fall 2022crwdne2935289:0
AUSTINCC-WATKINS-F22S9G2
crwdns2931471:04crwdne2931471:0
crwdns2935297:072crwdne2935297:0
