crwdns2915892:0crwdne2915892:0
If your motherboard gets broken by a bad fall or damage while replacing another part it will need to be replaced. Please note that all data is on the motherboard so you will lose your data.
crwdns2942213:0crwdne2942213:0
-
-
Remove the two 3mm screws using a PH00 screwdriver.
-
-
-
Use the blue plastic opening tool to gently pry the back case off.
-
-
-
-
Unsolder these wires from the motherboard, it is a good idea to label these wires as you remove them according to the picture to the left.
-
-
-
Remove contact strips by lifting gently on the clip indicated in this picture, then pulling strip out of the clip.
-
-
-
Remove the 3.5mm screws located at these locations shown on the picture by using the PH00 screwdriver.
-
-
-
Gently lift the motherboard out of the tablet, make sure no wires are still caught or attached while you lift the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.