crwdns2942213:0crwdne2942213:0
-
-
With the printer switched on, access the menu screen and select the option "Quick Configuration".
-
In the Quick Configuration menu select the option "Back off the Table".
-
-
-
When the table reach the position indicated in the picture, press the Reset button on the left side of the machine as shown.
-
Select the option "Pre-heat PLA" in the Quick Configuration menu.
-
-
-
With the table in position push the head manually toward the machine center in order to obtain an easy handling.
-
-
-
-
Position the 17mm Fixed Key as indicated in the picture, locking the inner part of the head to prevent the nozzle head from turning.
-
WIth the 7mm wrench take off the nozzle head.
-
-
-
With your hands, pull out the PTFE tube from the printhead by pressing the black piece of the part where the tube is seated
-
-
-
By positioning the drill bit into the indicated hole, push it down until the inner PTFE comes out from under the head (where the nozzle hole is).
-
-
-
Finish removing the inner PTFE and replace it with a new one or clean it.
-
With the drill bit, clean the nozzle hole, as shown in the figure.
-
Insert the new inner PTFE in place as shown.
-
-
-
Replace the nozzle at the bottom of the printhead and the PTFE at the top, pushing it all the way with your hands.
-
-
-
Reposition the table in the "Home XYZ" menu option in the fast settings section and wait until it is in the position indicated by the figure
-
You are ready to continue your impressions!
You are ready to continue your impressions!
crwdns2934873:0crwdne2934873:0
100%
crwdns2934885:0crwdne2934885:0 crwdns2934875:0crwdne2934875:0
crwdns2934877:0crwdne2934877:0 ›