crwdns2915892:0crwdne2915892:0
This guide will show you how to replace the Furby's light sensor circuit board.
crwdns2942213:0crwdne2942213:0
-
-
Use a flathead screwdriver to remove the two 10mm screws on the base of the Furby.
-
-
-
Use a Phillips #0 driver to unscrew the eight 10mm screws.
-
Remove the base ring after unscrewing all the screws.
-
-
-
Unhook the white ribbon from the tab on the base.
-
-
-
Roll the Furby's fur downward.
-
Disconnect the now exposed red wire.
-
-
-
Locate the two middle clips first.
-
Locate the two remaining clips on Furby's sides, they are opposite each other.
-
Orient the Furby upside down with the tail facing away from you.
-
-
-
-
Insert a metal prying tool directly into the clip opening.
-
Press upward into the clip. At the same time, use your other hand to pull away the plastic seam from the Furby's body.
-
Repeat the previous step to remove the remaining three clips.
-
-
-
Locate the two 10mm screws and remove them with the Phillips #0 head screwdriver.
-
Lift up on the fur covering until the face of the Furby is exposed.
-
-
-
Orient the Furby on its side to where the beak is facing left and locate the edge of the aluminum tape.
-
Lift tape gently and peel back until the tape is nearly removed.
-
-
-
Locate the four 10mm screws. Two on either side of body, and two on top of back plate, around the tape.
-
Remove the 10mm screws with the Phillips#0 screwdriver.
-
-
-
Peel the tape gently, grabbing it from the bottom edge and folding the tape upward.
-
-
-
Orient the Furby face down, with the base facing away from you.
-
Locate the clips below the ears.
-
Repeat the technique used in Step 6. Create leverage using a metal prying tool to press upward into the clip, while also pulling back on the clip itself.
-
-
-
Remove the loose, plastic back panel by pulling the panel away from Furby's body.
-
-
-
Remove the 10mm Phillips #0 screw holding the circuit board in.
-
Gently lift out the circuit board.
-
-
-
Orient the Furby with the tail pointing left and the face pointing right.
-
Use the pointed tweezers to spread open the socket, and the blunt tweezers to grip and tug out the connector.
-
Insert your replacement light sensor connector.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 15-5, Livingston Fall 2016 crwdns2935289:0Cal Poly, Team 15-5, Livingston Fall 2016crwdne2935289:0
CPSU-LIVINGSTON-F16S15G5
crwdns2931471:04crwdne2931471:0
crwdns2935297:09crwdne2935297:0
