crwdns2915892:0crwdne2915892:0
Use this guide to replace the levers inside the Hasbro Bop-It Micro Series game. The levers make the pull-it and twist-it handles function. When you pull or twist the handles, the levers push a sensor. The levers may be damaged if the game turns on but the handles don’t work.
Before using this guide, make sure to review the troubleshooting page.
crwdns2942213:0crwdne2942213:0
-
-
Loosen the two captive 8 mm screws in the back cover using a Phillips #0 screwdriver.
-
-
-
Remove the six 6 mm screws from the back cover using a Phillips #0 screwdriver.
-
When removing the final screw, hold the assembly together. There is a spring inside the device which will pop the assembly apart when all the screws are removed.
-
-
-
-
Carefully separate the two sections, leaving them connected by the wires.
-
-
-
Remove the white plastic levers with your fingers.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0