crwdns2915892:0crwdne2915892:0
If the game is turned on but the Bop-It button(s) does not work, this is because the button inside the device that provides functionality may be broken. To effectively replace them see this step-by-step guide.
crwdns2942213:0crwdne2942213:0
-
-
Loosen the two captive 8 mm screws in the back cover using a Phillips #0 screwdriver.
-
-
-
Remove the six 6 mm screws from the back cover using a Phillips #0 screwdriver.
-
When removing the final screw, hold the assembly together. There is a spring inside the device which will pop the assembly apart when all the screws are removed.
-
-
-
-
Carefully separate the two sections, leaving them connected by the wires.
-
-
-
Remove the buttons by de-soldering them from the wires they are attached to or from the mother board. Refer to the soldering guide here.
-
-
-
After removing the buttons, solder new, operational buttons back into place.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0