crwdns2915892:0crwdne2915892:0
If you have looked at the troubleshooting page and identified that your issues with your Onyx Studio 2 are indeed due to the circuit board being bad, this guide will walk you through how to replace it.
crwdns2942213:0crwdne2942213:0
-
-
Using a plastic opening tool, pry off the front grill by wedging it in the notch on the front of the device.
-
-
-
Remove the five 14.4 mm T10 Torx screws.
-
-
-
Gently pull the front apart from the back.
-
-
-
-
Remove the four wires connecting the front and back panels.
-
Pinch the connector tab and pull gently upwards.
-
Repeat for the other three connectors.
-
-
-
Pull the silicone button band off of the outer edge of the speaker.
-
-
-
Disconnect the two pressure connections from the circuit board.
-
-
-
Gently remove the control board band by placing fingers in contact with it through the button openings.
-
-
-
Disconnect the remaining connectors from the circuit board.
-
Disconnect the Bluetooth antenna.
-
-
-
Remove the four 10 mm T10 Torx screws.
-
Pull the circuit board out of the device as it is now free.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:011crwdne2935229:0
crwdns2947412:06crwdne2947412:0
Where do I get another one
Where we buy the board?
Umm… this was rather anticlimactic. Last step was basically like “and now contemplate your life choices”.
Where can I Buy a new hk onix studio Main board?
My speaker was working great. I just disconnected my phone to make a call, put YouTube back on it was all mumbled & the big button in the back kept pulsing so fast.