crwdns2915892:0crwdne2915892:0
If your Invoke is not connecting to your computer in order to be serviced, there might be a problem with the service port and should be replaced. For this replacement you will need a metal spudger and a #10 Torx screwdriver.
crwdns2942213:0crwdne2942213:0
-
-
Use a metal spudger to remove the rubber bottom.
-
-
-
Use a #10 Torx screwdriver to remove four 14 mm screws.
-
-
-
-
Firmly grip the bottom and wiggle upwards to remove the base.
-
-
-
Use a #10 Torx screwdriver to remove two 10 mm screws from board attached to ports.
-
Pull board up lightly.
-
-
-
Pull cable to disconnect board from device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0