crwdns2915892:0crwdne2915892:0
This guide is created for the replacement of oxygen cells in the Hamilton-T1 Ventilator. Replacing the oxygen cells is a crucial step in maintaining and keeping a working ventilator.
NOTE:
- Replace the oxygen cell with genuine Hamilton Medical parts only; otherwise, oxygen measurement will not function. To prevent a permanent alarm make sure to use special Hamilton Medical oxygen cells only.
- To prevent leakage within the ventilator, make sure an oxygen cell is installed at all times, even if you use an external monitor or disable oxygen monitoring.
crwdns2942213:0crwdne2942213:0
-
-
Flip device around until the back panel is exposed.
-
-
-
Remove the screw in the bottom center of the panel, and then take the panel off.
-
-
-
Disconnect the oxygen cell by removing the tube.
-
Then twist the cell counter-clockwise and pull to remove the oxygen cell.
-
Install the new oxygen cell and put the back cover on.
-
-
-
After the cell is installed. Run the oxygen cell calibration.
-
Oxygen calibration guide can be found in 3-11 of the Hamilton-T1 operations manual.
-
After the installation and calibration of the oxygen cell. The Hamilton-T1 Ventilator is ready to operate.
After the installation and calibration of the oxygen cell. The Hamilton-T1 Ventilator is ready to operate.
crwdns2935103:0crwdne2935103:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team S11-G24, Paton Spring 2020 crwdns2935289:0Cal Poly, Team S11-G24, Paton Spring 2020crwdne2935289:0
CPSU-PATON-S20S11G24
crwdns2931471:03crwdne2931471:0
crwdns2935297:03crwdne2935297:0
