crwdns2915892:0crwdne2915892:0
Replacement of the power cord. Make sure to keep the processor unplugged until finished with replacement.
crwdns2942213:0crwdne2942213:0
-
-
Turn the bowl counterclockwise and lift.
-
-
-
Using a #2 Phillips head screwdriver, remove the two 11 mm screws from the base.
-
Pull suction cups straight out.
-
-
crwdns2935267:0crwdne2935267:0Heavy-Duty Spudger$4.99
-
Remove rubber caps using the heavy duty spudger.
-
Remove the four 11 mm screws using the #2 Phillips head screwdriver.
-
Pull base straight out.
-
-
-
-
Using a #2 Phillips head screwdriver, remove the four 9 mm screws.
-
From the open base pull the motor straight out.
-
-
-
Using the wire stripper crimping tool cut the black wire connection from the power cord to the motor and then rewire the new power cord to the motor.
-
-
-
Remove the two 12 mm screws using the #2 Phillips head screwdriver.
-
Remove plastic piece.
-
-
-
Remove the three 12 mm screws using the #2 Phillips head screwdriver.
-
Remove the plastic piece by pulling straight up.
-
-
-
Remove the power cord from the ground by removing the solder with the soldering tool.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
USF Tampa, Team 17-4, Blackwell Spring 2017 crwdns2935289:0USF Tampa, Team 17-4, Blackwell Spring 2017crwdne2935289:0
USFT-BLACKWELL-S17S17G4
crwdns2931471:03crwdne2931471:0
crwdns2935297:07crwdne2935297:0
