crwdns2915892:0crwdne2915892:0
After using this guide you will have learned how to replace the power button to your blender. You will need to use basic tools and soldering to complete this guide.
crwdns2942213:0crwdne2942213:0
-
-
-
Remove the container from the base.
-
Hold the blender and the container, then twist the container in a clockwise motion.
crwdns2952109:0crwdne2952109:0
-
-
-
Turn the blender so the bottom is facing you.
-
Using a Phillips #2 screwdriver, remove the two 5 mm Phillips screws from the base.
-
-
-
-
Using a Phillips #2 screwdriver, remove the two 5 mm Phillips screws from the motor platform.
-
-
-
Unhinge the motor platform from the blender.
-
-
-
Pull out the rectangular green piece.
-
-
-
On the back of the power button, desolder the red and grey wires that are connected to the piece.
-
-
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2935287:0crwdne2935287:0
USF Tampa, Team 2-5, Sullivan Fall 2015 crwdns2935289:0USF Tampa, Team 2-5, Sullivan Fall 2015crwdne2935289:0
USFT-SULLIVAN-F15S2G5
crwdns2931471:04crwdne2931471:0
crwdns2935297:060crwdne2935297:0
