crwdns2915892:0crwdne2915892:0
After using this guide you will have learned how to replace the motor to your blender. You will need to use basic tools and soldering to complete this guide.
crwdns2942213:0crwdne2942213:0
-
-
Remove the container from the blender.
-
Hold the blender and the container, then twist the container in a clockwise motion.
-
-
-
Turn the blender so the bottom is facing you.
-
Using a Phillips #2 screwdriver, remove the two 5 mm Phillips screws from the base.
-
-
-
Using a Phillips #2 screwdriver, remove the two 5 mm Phillips screws from the motor platform.
-
-
-
-
Unhinge the plastic motor platform from the blender.
-
-
-
Using a spudger, carefully insert the tip into the coil of wire around motor.
-
-
-
Remove the white rotor piece by rotating it counter-clockwise.
-
-
-
Move the motor platform to the side.
-
Lift up the motor and remove it from the blender.
-
-
-
Desolder the red wire from the green plastic piece.
-
-
-
Cut the thin black wire from the wire cap.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
USF Tampa, Team 2-5, Sullivan Fall 2015 crwdns2935289:0USF Tampa, Team 2-5, Sullivan Fall 2015crwdne2935289:0
USFT-SULLIVAN-F15S2G5
crwdns2931471:04crwdne2931471:0
crwdns2935297:06crwdne2935297:0
crwdns2947412:02crwdne2947412:0
This article appears to be unfinished. You cut 2 wires at the end... then what? Reconnecting them doesn't make any sense.
Que tipo de motor tengo que comprar?
