crwdns2915892:0crwdne2915892:0
The vibration motor is the component in a mobile device that causes the device to vibrate. If your device is not vibrating when you receive a notification, you should consider replacing the vibration motor in your device. Use this guide to replace the vibration motor in your device.
crwdns2942213:0crwdne2942213:0
-
-
Turn off your cell phone before disassembling.
-
-
-
Remove the two 1.17mm Torx T3 screws from the bottom of the phone.
-
-
-
Use the Sim card ejection tool to remove both the sim card trays.
-
-
-
-
To prepare the iOpener insert it in the microwave for 30 seconds and apply it on the side edges of the phone so that the glue underneath will soften.
-
-
-
Pry off the back with a plastic opening tool.
-
-
-
Remove the five 1.5mm Phillips #000 screws from the motherboard.
-
-
-
Use a plastic opening tool to pry up and disconnect the display cable from the motherboard.
-
Use tweezers to disconnect the white coax cable.
-
Use tweezers to disconnect the power and volume cable.
-
-
-
Using the metal spudger, pry the adhered vibration monitor to remove.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
The Citadel Military College of South Carolina, Team S2-G11, Eggleston Spring 2020 crwdns2935289:0The Citadel Military College of South Carolina, Team S2-G11, Eggleston Spring 2020crwdne2935289:0
CMCSC-EGGLESTON-S20S2G11
crwdns2931471:03crwdne2931471:0
crwdns2935297:05crwdne2935297:0
