crwdns2915892:0crwdne2915892:0
If the device does not recognize fingers correctly, replacing the fingerprint scanner may solve this issue.
crwdns2942213:0crwdne2942213:0
-
-
Turn off your cell phone before disassembling.
-
-
-
Remove the two 1.17mm Torx T3 screws from the bottom of the phone.
-
-
-
Use the Sim card ejection tool to remove both the sim card trays.
-
-
-
To prepare the iOpener insert it in the microwave for 30 seconds and apply it on the side edges of the phone so that the glue underneath will soften.
-
-
-
-
Pry off the back with a plastic opening tool.
-
-
-
Remove the five 1.5mm Phillips #000 screws from the motherboard.
-
-
-
Use a plastic opening tool to pry up and disconnect the display cable from the motherboard.
-
Use tweezers to disconnect the white coax cable.
-
Use tweezers to disconnect the power and volume cable.
-
-
-
Pull the fingerprint scanner out of its housing.
-
-
-
This is what the mother board should look like when the fingerprint scanner is pulled out.
-
To fix the fingerprint scanner simply add in a new one and attach the metal component to its coordinating place.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
USF Tampa, Team S7-G6, Passmore Spring 2018 crwdns2935289:0USF Tampa, Team S7-G6, Passmore Spring 2018crwdne2935289:0
USFT-PASSMORE-S18S7G6
crwdns2931471:03crwdne2931471:0
crwdns2935297:012crwdne2935297:0
