crwdns2915892:0crwdne2915892:0
Be cautious about the ribbon cable
crwdns2942213:0crwdne2942213:0
-
-
First remove the back cover of your phone to expose the battery.
-
-
-
Turn the phone over.
-
Push forward on the battery with your thumb.
-
-
-
Take the battery out by lifting it upwards.
-
-
-
Remove the four 4.9mm T6 Torx screws that secure the back panel to the rest of the phone.
-
-
-
-
Remove the two 4.3mm Phillips #00 screws that secure the back panel to the rest of the phone.
-
-
-
Insert the plastic opening tool along the seams at different points to it pry the clips off.
-
-
-
Remove the one 3.3mm Phillips #00 screw.
-
-
-
Use your finger or the plastic opening tool to unclip the board.
-
-
-
Peel off the yellow piece of tape from the phone.
-
-
-
Flip up the retaining flap with your fingernail or a plastic opening tool.
-
Pull on the ribbon cable gently with your fingers.
-
-
-
Split apart the motherboard and front panel.
-
Remove the other yellow piece of tape off of the end of the ribbon cable.
-
-
-
Gently pull on the ribbon cable to separate the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.