crwdns2915892:0crwdne2915892:0
The purpose of this guide is to instruct the reader on how to replace the LCD screen of their HP iPAQ H2200 device.
crwdns2942213:0crwdne2942213:0
-
-
Press and slide the battery cover tab to remove battery cover.
-
-
-
Pull on the black tab to lift the battery out of the battery compartment.
-
-
-
Remove the stylus by sliding it out of the slot.
-
-
-
Remove the CF card by sliding it out of the slot at the top of the device.
-
-
-
Press down and push the black side strips toward the top of the device to remove them.
-
-
-
-
Using the T5 Torx screwdriver, remove all six screws on the back and all screws on each side of the device.
-
-
-
Remove the back faceplate by pushing and loosening the 4 side slots (2 on each side).
-
-
-
Open the LCD connector, where the orange strip attaches to the main board.
-
-
-
Carefully remove the orange LCD strip from the connector.
-
-
-
Unscrew the 2 screws located at each top corner of the main board.
-
-
-
Remove the main board by pushing outward on the two tabs located on each side near the bottom of the device.
-
-
-
Unscrew the two bottom screws on LCD screen that were previously located under the main board.
-
-
-
Press on side tabs to loosen and remove the LCD screen.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0