crwdns2915892:0crwdne2915892:0
The user will be taking apart the front panel from the back panel in order to work on the HP Split 13-r010dx.
crwdns2942213:0crwdne2942213:0
-
-
Locate the four screws at the bottom of the device. (Note that the keyboard attachment is missing from this device.)
-
Use a Philips head #0 screwdriver to remove each of the screws (Size: 4mm)
-
-
-
Gently wedge the plastic opening tool in between where the display and back panel meet.
-
Slowly and gently apply force to the plastic opening tool in a downwards motion to loosen the front panel from the back panel.
-
Rotate the device so that the side is facing up and repeat the previous step for the sides.
-
Do NOT attempt to wedge the plastic opening tool on the bottom . Once the sides and top are loose you are ready to continue to the next step.
-
-
-
-
Gently and slowly pull the front and back panel away from each other (in opposite directions). ( Pulling them apart will not separate the two panels)
-
Only separate the panels by a few inches from each other so that there is room to separate the front and back panel in the next step. Proceed to the next step.
-
-
-
Hold the back panel firmly and pull the front panel upwards to completely separate the front panel from the back panel.
-
The device is now ready to be repaired or replacements installed.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
University of North Texas, Team S2-G1, Thompson Fall 2017 crwdns2935289:0University of North Texas, Team S2-G1, Thompson Fall 2017crwdne2935289:0
UNT-THOMPSON-F17S2G1
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
