crwdns2915892:0crwdne2915892:0
This guide will instruct you on how to remove and replace the motherboard. Replacement of the motherboard may be necessary if the laptop is not turning on or booting.
crwdns2942213:0crwdne2942213:0
-
-
Turn off and unplug the laptop.
-
Flip over the laptop so that the bottom backplate is exposed.
-
-
-
Use a T5 screwdriver to remove the six 3 mm screws that secure the backplate.
-
Use the same screwdriver to remove the two 7 mm screws.
-
-
-
Insert an opening tool under the bottom cover at the screen hinges, and gently pry the cover free.
-
Carefully work your way around the cover's edges to pop it off completely.
-
-
-
With the backplate removed, remove the four 3 mm screws securing the battery with a Phillips #1 screwdriver.
-
With the screws removed, disconnect the 3 wires connected to the battery.
-
-
-
-
Use a Phillips #0 Screwdriver to remove the four circled 3 mm screws.
-
Use the same screwdriver to remove the circled 4 mm screw.
-
-
-
Remove black adhesive tape and metal shielding.
-
-
-
Use a Phillips #0 screwdriver to remove the last 4 mm screw under the black tape.
-
Unplug the cable next to the fan.
-
-
-
Use a Phillips #0 Screwdriver to remove the 2.6 mm and 2.7 mm screws.
-
-
-
For the strip wires, push the white tab seen in the photo up gently and slowly pull the strip wire.
-
The normal wires can be removed by holding the sides of the connector and gently pulling away.
-
Finally, the screws can be removed.
-
-
-
You may now pull the motherboard off the computer to access it.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.