crwdns2915892:0crwdne2915892:0
Is your HP Spectre x360 13-aw0xxx not maintaining power and dying quickly? If so use this guide to help you replace your battery step by step. You will need two opening tools, a Phillips #00 screwdriver, and a T5 Torx screwdriver to complete this replacement.
crwdns2942213:0crwdne2942213:0
-
-
Remove the following screws securing the lower case:
-
Four Phillips #00 6 mm screws
-
Two T5 Torx 3 mm screws
-
-
-
Insert an opening tool in the seam between the lower case and chassis.
-
Pry around the perimeter until the lower case fully releases.
-
Remove the lower case.
-
-
-
-
Use two opening tools, one on either side of the battery plug, to slowly pull the plug straight out of its port.
-
-
-
Use a Phillips #00 screwdriver to remove the six 2.5 mm screws securing the battery.
-
-
-
Carefully lift the edge of the battery with an opening tool.
-
Lift the battery up and out.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Western Carolina University, Team 1-6, Virtue Spring 2023 crwdns2935289:0Western Carolina University, Team 1-6, Virtue Spring 2023crwdne2935289:0
WCU-VIRTUE-S23S1G6
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
crwdns2947410:01crwdne2947410:0
I just replaced the battery using the ifixit battery mentioned here. Everything was working fine until I realized that my laptop shut down, the battery ran out in about 1 hour and the BIOS screen said that a non-hp battery has been detected.
