crwdns2915892:0crwdne2915892:0
Make sure device is powered off and unplugged from any power source.
crwdns2942213:0crwdne2942213:0
-
-
Power off device.
-
Flip laptop over.
-
-
-
Remove the rubber foot with a Metal spudger
-
Remove 5 Phillip 2.4 x 5.7mm screws using a PH0 Phillips head screwdriver.
-
Remove 5 Phillips 2.8 x 5.0mm screws using a PH0 Phillips head screwdriver.
-
-
-
-
Open computer and pry open keyboard panel using the Metal Spudger. Apply little pressure then increase until keyboard pops away from motherboard.
-
Gently lift keyboard on the mouse pad side. Remove three connected ribbon wires connecting keyboard to frame by gently disconnecting them from the motherboard.
-
-
-
Remove eleven 2.0 x 4.6mm screws using the Phillips 00 Screwdriver
-
-
-
Remove the motherboard gently from the base of the laptop.
-
Disconnect the fastened cables from the motherboard by carefully pushing the cable's plastic edges using the metal Spudger.
-
-
-
Using the Phillips 00 Screw Driver. remove 4 screws from the heat sink.
-
Remove any adhesive tape. Detach the fan/heat sink.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0