crwdns2915892:0crwdne2915892:0
The battery is defective if the power is draining quickly after a full charge, or doesn't receive charge at all. Then use this guide.
crwdns2942213:0crwdne2942213:0
-
-
Shut down the computer.
-
Disconnect the power and all external devices connected to the computer.
-
-
-
Use a Metal Spudger and remove the rubber foot closet from the bottom of the laptop.
-
-
-
Remove all of the screws located on the bottom of the laptop:
-
5 Phillips 2.4 x 5.7 mm screws
-
5 Phillips 2.0 x 5.0 mm screws
-
-
-
Turn the computer over onto its base, with the computer open and the keyboard facing upward.
-
-
-
-
Use the Plastic Opening Tool to separate the keyboard from the base of the laptop.
-
-
-
Raise the keyboard slightly to access the touch pad and keyboard cables.
-
-
-
Disconnect the ribbon cables attaching the touch pad and keyboard to the system board (motherboard).
-
Using the Heavy-Duty Spudger lift up the plastic locks connecting the ribbon cable to the motherboard.
-
Use the blue plastic tab on the ribbon cable to pull it out from the lock on the motherboard.
-
-
-
Lift the keyboard away from the base of the laptop.
-
-
-
Using the Phillips 00 Screwdriver, remove 6 Phillips 2.0 x 4.6 mm screws from the perimeter of the battery.
-
Follow these instructions in reverse order to reassemble your device.
Follow these instructions in reverse order to reassemble your device.
crwdns2935221:0crwdne2935221:0
crwdns2935229:07crwdne2935229:0
crwdns2915084:0crwdne2915084:0
UW Tacoma, Team 1-6, Rose Winter 2017 crwdns2935289:0UW Tacoma, Team 1-6, Rose Winter 2017crwdne2935289:0
UWT-ROSE-W17S1G6
crwdns2931471:04crwdne2931471:0
crwdns2935297:08crwdne2935297:0
crwdns2944067:02crwdne2944067:0
Thanks for this easy step by step guide. The pictures were incredibly helpful!
I replaced the battery now the screen doesn't turn on. I plugged it into an external monitor and the computer works fine and even the touch aspect of the screen works, but it stays black. Did i accidentally disconnect something?
