crwdns2915892:0crwdne2915892:0
If the speakers in your HP Pavilion x360 11m-ad013dx are in need of replacement or have stopped functioning properly, use this guide to replace the speakers. For more information about malfunctioning or nonfunctioning speakers, see our troubleshooting page HP Pavilion x360 11m-ad013dx Troubleshooting. The speakers are responsible for producing sound in the laptop. They also give access to work on the motherboard when removed.
crwdns2942213:0crwdne2942213:0
-
-
Lay the HP Pavilion top-down with the front edge facing towards you.
-
-
-
Remove the three 4.8mm Phillips #0 screws from the front side.
-
-
-
Using a plastic spudger, remove the grey silicon strip closest to the back-side.
-
-
-
Remove the three 5.7mm Phillips #1 screws.
-
-
-
Open the HP Pavilion so that the screen is showing. Then tilt it down so that the screen is on its back, facing up.
-
Using a spudger, pry off the black keyboard panel.
-
-
-
-
Using your fingernail, disconnect the zero insertion force (ZIF) keyboard connector cable by flipping up the small locking flap.
-
-
-
Using your fingernail, disconnect the zero insertion force (ZIF) connector for the touch pad cable by flipping up the small locking flap.
-
-
-
Remove the five 4.6mm Phillips #1 screws located around the battery.
-
-
-
Using a spudger for assistance, lift up the right edge of the battery.
-
Remove the battery.
-
-
-
Using your fingernail, disconnect the ZIF (zero insertion force) hard drive cable by flipping up the small locking flap.
-
-
-
With your fingernails, disconnect the speaker cable from the motherboard by pulling back on the connector.
-
-
-
Lift the speaker cable from its retention chamber.
-
-
-
Remove the four 6.2mm Phillips #1 screws around the speakers.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.