crwdns2915892:0crwdne2915892:0
If the camera on your HP Pavilion dv6000 needs to be repaired, follow this guide.
crwdns2942213:0crwdne2942213:0
-
-
Remove rubber screw covers from the LCD screen. They cover the screws. The stops on the top of the screen pop off, but the lower covers require a screwdriver to remove.
-
If you need to use the screwdriver to remove the rubber screw covers, gently push the screwdriver down the edge of the stopper and then use the screwdriver as a lever to pry the cover from the hole.
-
Remove the six 7.15mm screws underneath the stoppers. There are four on top and two on bottom.
-
-
-
Press the tabs in on the sides of the screen and pop the plastic covering off.
-
-
-
-
Lift the screen out of the casing at the top near the camera.
-
-
-
Gently remove the main cable from the camera.
-
-
-
There are three clasps holding the camera down. Gingerly lift the camera board up, being careful not to snap the board, clasps, or vertical plastic pins (inside the gold-colored rings).
-
-
-
Remove the camera unit from the laptop and you are done!
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0