crwdns2915892:0crwdne2915892:0
HP Pavilion Wave comes with a pair of built-in mouse and keyboard. This guide shows you how to replace them without using any additional USB-port for your mouse and keyboard.
crwdns2942213:0crwdne2942213:0
-
-
Turn over the computer and remove the rubber feet.
-
Remove the 8mm Philips screws indicated in red circles with a Philips #0 screwdriver.
-
Use a pry tool and lift the lid.
-
-
-
Pry open the casing from the back of the IO panel, as shown in the pictures.
-
-
-
-
Finally, remove the two cables circled in red from the front IO panel.
-
-
-
Locate a blue USB adapter on the left side of the hard disk compartment.
-
-
-
Take off the USB with gentle but firm pressure.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team S8-G4, Banghart Fall 2017 crwdns2935289:0Cal Poly, Team S8-G4, Banghart Fall 2017crwdne2935289:0
CPSU-BANGHART-F17S8G4
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
crwdns2944067:03crwdne2944067:0
Seems like there might be enough room for a usb 2 port hub/splitter (such as Onvian USB Splitter Cable Male to 2 Female Adapter USB) to add an additional usb dongle (such an RF or Insteon USB)? Can you confirm how much room there are?
Since it's a year old project, I forgot most of the dimensions, but from my memory, it would be possible since it's located in a little groove that can probably fit a wire or two. (You can see it in step one picture)
Can i purchase this dongle anywhere? Is there any documentation on how to pair?
