crwdns2915892:0crwdne2915892:0
If your HP Pavilion G6-1d16dx won't close/open correctly, you could have a faulty screen hinge. This guide walks users through the process of accessing/replacing the screen hinges so that their computer will open and close correctly.
Before following this guide, check to see if there is anything external that may be inhibiting your screen from closing correctly, or if there is any sort of dust or debris buildup in the hinges of your computer; any buildup can typically be removed with an air duster.
Before beginning, be sure that your computer is fully turned off and unplugged from any power source.
crwdns2942213:0crwdne2942213:0
-
-
Flip the computer so that the bottom side is facing up, and locate the battery above the screen hinges.
-
-
-
Slide the switch under the battery compartment to release the battery.
-
-
-
Unscrew the two silver screws holding the protective cover in place until they make a clicking noise.
-
-
-
Unsnap the Cover by lifting the edge along the battery compartment.
-
Remove all of the body screws.
-
Remove the rubber cap and the screw underneath it.
-
-
-
Using a metal tool, depress the center tab and pry up the keyboard by pivoting the tool towards the screen.
-
-
-
-
Slide the tool that is now under the keyboard sideways along the edge and use another tool to depress the other tabs along the edge of the keyboard.
-
Lift off the keyboard
-
-
-
Flip up the black tab holding the keyboard in place via the ribbon cable and pull out the cable
-
-
-
Remove the two remaining ribbon cables.
-
Remove the screws holding in the protective cover underneath the keyboard.
-
Pop the cover off using any flat metal tool, starting with where you took out the optical drive
-
-
-
Unplug the ribbon cable on the right side of the motherboard.
-
-
-
Underneath the computer, unscrew the hard drive connector screw, and pop out the hard drive plug-in.
-
-
-
Unscrew all mother board screws and lift the motherboard out of the body.
-
-
-
Remove the five screws holding hinges to base.
-
-
-
Lift the tape tab up from the screen plug, and unplug the screen from the motherboard.
-
Unplug the wires from the wireless card and pull them through the body.
-
-
-
Remove the sticky tabs on the bottom of the screen just outside the hinges, and remove the two screws underneath.
-
-
-
Pry off the plastic surrounding the screen with any flat metal tool.
-
-
-
Remove the screws holding the hinge covers in place.
-
Remove the hinge covers.
-
-
-
Use a pair of pliers to unscrew the nut and pull out the hinge.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Linn Benton Community College, Team S2-G6, Johnson Spring 2018 crwdns2935289:0Linn Benton Community College, Team S2-G6, Johnson Spring 2018crwdne2935289:0
LBCC-JOHNSON-S18S2G6
crwdns2931471:04crwdne2931471:0
crwdns2935297:08crwdne2935297:0
crwdns2917034:0crwdne2917034:0
Not so good a manual. See my remarks.
This laptop is of extremely poor building quality. Disaster lures in every badly made detail.
