crwdns2915892:0crwdne2915892:0
The hard drive may malfunction if physically damaged or put under a lot of stress. Use this guide to replace it if the computer won't boot and or is displaying errors.
crwdns2942213:0crwdne2942213:0
-
-
Slide the black battery latches inward to remove the battery.
-
-
-
Pull the battery out towards you while your fingers are still holding the latches in place.
-
-
-
Remove one 7 mm screw with a Phillips #1 screwdriver.
-
-
-
Use a metal spudger to push the CD drive out of its slot for removal.
-
-
-
Remove fifteen 7 mm screws with a Phillips #1 screwdriver.
-
-
-
Remove the thin plastic cover using the flat metal spudger to expose another screw.
-
Remove one 7 mm screw with a Phillips #0 screwdriver.
-
-
-
Use a metal spudger to remove the rubber "feet" to expose two screws.
-
-
-
-
Underneath each rubber foot, there is a screw.
-
Use the Phillips #1 screwdriver to remove a 4.8 mm screw on each side.
-
-
-
Remove the two black end caps to expose more screws.
-
-
-
Remove the following six screws with a Phillips #1 screwdriver:
-
Two 7 mm screws.
-
Two 7 mm screws.
-
Two 4.8 mm screws.
-
-
-
Remove two 2.4 mm broadhead screws from the CD Drive bay with a Phillips #0 screwdriver.
-
-
-
Flip the laptop back over. Then, with the laptop open, move the plastic prying tool around the top cover to pry it from the enclosure.
-
-
-
Partially lift the top cover from the enclosure.
-
-
-
Remove the ribbon connecting the power button to the motherboard.
-
-
-
Remove the ribbon connecting the mousepad to the motherboard.
-
-
-
Remove the ribbon connecting the keyboard to the motherboard.
-
You may now fully lift the front panel from the rest of the laptop.
-
-
-
Lift the black retaining bar that holds down the two hard drive ribbons to unlock them.
-
-
-
Lift the hard drive out from the enclosure.
-
-
-
Pull the rubber casing away from the hard drive.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:09crwdne2935229:0
crwdns2947412:02crwdne2947412:0
Thank you. Couldn’t figure out why those end caps wouldn’t budge. Dang hidden screws! Kudos!
Greet thank to you ! This tuto was very helpfull for me !