crwdns2915892:0crwdne2915892:0
Using a spudger and a 00 Phillips head screwdriver, this guide will show how to remove a pair of speakers from an HP Omni 10 tablet in roughly 5 to 7 minutes.
crwdns2942213:0crwdne2942213:0
-
-
Remove the back cover from the tablet.
-
-
-
Push the black plastic security flaps into an upward position.
-
Lift the small tab on the security strips up and peel them across the battery. They will be attached via adhesive.
-
Lift the tab on the strip up and pull it across the battery.
-
-
-
Unscrew the ten 3.3 mm screws securing the battery using a 00 Phillip's head screwdriver.
-
-
-
Unhook the cord from the edge of the battery.
-
Pull the wire circuit out and down.
-
-
-
-
Lift the battery up by its edges and remove it carefully. There will be adhesive holding the battery down.
-
-
-
Unscrew the two 3.3 mm screws using a 00 Phillip's head screwdriver.
-
-
-
Lift and remove micro card reader board.
-
-
-
Unscrew the four 3.3 mm screws using a 00 Phillip's head screwdriver.
-
-
-
Pull the black and white wire connector up to disconnect it.
-
-
-
Pull the red and black wire connector up to disconnect it.
-
-
-
Lift the speaker set out of their sockets.
-
-
-
Unhook the left speaker's connector wire to fully remove it from the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
USF Tampa, Team 1-1, Leahy Fall 2016 crwdns2935289:0USF Tampa, Team 1-1, Leahy Fall 2016crwdne2935289:0
USFT-LEAHY-F16S1G1
crwdns2931471:03crwdne2931471:0
crwdns2935297:010crwdne2935297:0
crwdns2947410:01crwdne2947410:0
its order when i will get it please candly I request
