crwdns2915892:0crwdne2915892:0
This guide will demonstrate how to replace the fan and heatsink in the HP Envy x360 15m-cn0011dx laptop. The fan in this computer is connected to a heating pipe/heat sink. Be careful when removing the fan along with the heatsink as these parts are very fragile with a fair amount of force.
Make sure your device is fully powered off before attempting this guide.
crwdns2942213:0crwdne2942213:0
-
-
Flip the laptop over to the back side.
-
-
-
Remove the six 5.6 mm screws from the back cover using a Phillips #00 screwdriver.
-
Remove the single 4.3 mm screw in the bottom middle section of the back cover using a T5 Torx screwdriver.
-
-
-
-
Loosen the four captive screws on the heat sink using a Phillips #00 screwdriver.
-
-
-
Remove two 10 mm screws from the fan using a Phillips #00 screwdriver.
-
-
-
Unplug the fan from the motherboard and lift the fan and heatsink out of the laptop.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Gateway, Team 1-4, Class Fall 2022 crwdns2935289:0Gateway, Team 1-4, Class Fall 2022crwdne2935289:0
GCC-CLASS-F22S1G4
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
