crwdns2915892:0crwdne2915892:0
Has your device not been connecting to Wi-Fi? Here are the steps to remove and replace the Wi-Fi card in your HP Envy x360 15m-bq021dx safely. Before performing this, try installing new network drivers or running a windows network diagnostic. Additionally, power off your device and disconnect it from the power adapter prior to beginning the repair.
crwdns2942213:0crwdne2942213:0
-
-
On the back panel of the device, remove the four (4) M2.5xL6 screws at the top of the photo using a Phillips #0 screwdriver.
-
Unscrew the three (3) screws at the bottom of the photo using a T5 Torx screwdriver.
-
-
-
To remove the back cover, use the black spudger to lift up on the edges of the cover.
-
Use a suction cup to assist in lifting the back cover
-
-
-
Use the Philips #0 screwdriver to remove six (6) M2.0x3.2 screws from battery.
-
-
-
Using the Philips #0 screwdriver, remove the final screw from the battery connected to the SSD storage unit.
-
-
-
Lift and pull the front of the battery up and out (away from the connector) to remove.
-
-
-
-
Using a Philips #0 screwdriver, remove the three M2x4 screws located around the cooling fan as shown in this picture.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Remove the connector clip with the tweezers.
-
-
-
Remove the four spring loaded screws with a Philips #1 screwdriver.
-
-
-
Using a Phillips #1, remove the seven M2.0x3.2 screws.
-
Undo the six connections using the blue opening tool.
-
-
-
Carefully remove the aux port from the frame of the computer as shown.
-
-
-
Pull the mother board up and away from frame of the computer.
-
-
-
Flip the motherboard over.
-
Pull the Wi-Fi card out from the slot.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.