crwdns2915892:0crwdne2915892:0
This guide is used to help you replace RAM for HP Envy Ultrabook 4-1043cl. It can be time to change the RAM when your laptop works unexpectedly slow. This guide provides detailed step by step instructions to ensure your success replacement. You may need an Ifixit PRO TECH TOOLKIT to remove the screws and unwarp the bottom enclosure. Before you start, make sure the charger is DISCONNECTED and the laptop is shut down for safety reasons. And always remember to remove the battery before trying to disconnect hard disk drive. Meanwhile, it is highly recommended to use different containers to place the removed screws from different parts in case you may forget where some screws belong to. If the laptop goes blue-screen after you replace it, this means the new-replaced RAM is poorly-connected and you should reconnect it.
crwdns2942213:0crwdne2942213:0
-
-
Flip the laptop over so the bottom is facing you.
-
-
-
Remove twelve 7.5 mm screws by using the Phillips #00 screwdriver.
-
-
-
Use plastic opening tool to remove the back cover.
-
-
-
-
Remove three 4.2mm screws by using the Phillips #00 screwdriver.
-
-
-
Disconnect the battery cable from the motherboard and remove the battery from the device.
-
-
-
The RAM lies in the middle-right side of the device.
-
Use your fingers and push the two clips outwards to release the RAM stick.
-
-
-
Repeat the previous two steps to remove any other RAM sticks.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Duke University Pratt School of Engineering, Team S5-G1, Matos-Garner Fall 2019 crwdns2935289:0Duke University Pratt School of Engineering, Team S5-G1, Matos-Garner Fall 2019crwdne2935289:0
DUKEPSE-MATOS-GARNER-F19S5G1
crwdns2931471:05crwdne2931471:0
crwdns2935297:04crwdne2935297:0
