crwdns2915892:0crwdne2915892:0
The back panel on the HP Envy 17 is a simple plate that covers the underside of the laptop. Once removed it gives easier access to laptop components such as the WLAN module and RAM module. This is a crucial step in order to delve deeper into the device.
crwdns2942213:0crwdne2942213:0
-
-
Lay the laptop with the battery facing towards you.
-
-
-
Grab hold of the small battery slider and apply pressure to the right.
-
The laptop itself will push the battery out for you once the switch slides all the way to the right.
-
-
-
-
Pull the battery out and let go of the battery slider.
-
-
-
Use a PH1-screwdriver to loosen the 7mm screw. The screw will not fully come out as it is held by a washer underneath but will come out enough to open it.
-
-
-
Gently pull the back panel off starting from the battery side towards the back.
-
Pull it back as it snaps out of the holding sockets.
-
To reassemble your device, place the back panel from opposite the battery end in the slots and place down until it snaps into place.
To reassemble your device, place the back panel from opposite the battery end in the slots and place down until it snaps into place.
crwdns2915084:0crwdne2915084:0
USF Tampa, Team 16-6, Blackwell Spring 2017 crwdns2935289:0USF Tampa, Team 16-6, Blackwell Spring 2017crwdne2935289:0
USFT-BLACKWELL-S17S16G6
crwdns2931471:03crwdne2931471:0
crwdns2935297:06crwdne2935297:0
