crwdns2915892:0crwdne2915892:0
Use this guide to replace the heat sink and fan of your HP EliteBook 840 Aero G8. The heat sink and fan need to be replaced if your device is overheating and not performing properly. Be sure to remove the battery before removing the heat sink and fan, as potential for electric shock is present.
crwdns2942213:0crwdne2942213:0
-
-
Use a JIS #0 screwdriver to unscrew the three 6.73 mm case retention screws.
-
Use a JIS #0 screwdriver to unscrew and remove the two 8.76 mm screws.
-
-
crwdns2935267:0crwdne2935267:0Halberd Spudger$2.99
-
Use the Halberd Spudger to remove the cable running along the bottom of the battery
-
-
-
Disconnect the cable connected the battery to the motherboard
-
-
-
Use a JIS #0 screwdriver to unscrew the four 7 mm screws that secure the battery.
-
-
-
-
Slide the battery out of the clips to remove it from the laptop.
-
-
-
Unplug the fan cable from the motherboard.
-
-
-
Use the JIS #0 screwdriver to remove the three 5.33 mm screws that secure the fan.
-
-
-
Use a JIS #0 screwdriver to remove the four 4.06 mm screws from the heat sink.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
The Citadel Military College of South Carolina, Team 3-15, Eggleston Fall 2022 crwdns2935289:0The Citadel Military College of South Carolina, Team 3-15, Eggleston Fall 2022crwdne2935289:0
CMCSC-EGGLESTON-F22S3G15
crwdns2931471:03crwdne2931471:0
crwdns2935297:04crwdne2935297:0
