crwdns2915892:0crwdne2915892:0
This guide can help if your power or volume buttons are broken. The power/ volume board may not be completely attached to the control board so be careful when unhooking the clip.
crwdns2942213:0crwdne2942213:0
-
-
Using a Torx T4 screwdriver, remove the four 5 mm screws on the back panel.
-
-
-
Insert the tip of a plastic opening tool in the seam between the front and back panels.
-
-
-
-
Slide the plastic opening tool around all edges of the device until the back panel detaches.
-
Lift off the back panel.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Disconnect the power/ volume button board from the control board by pulling the ribbon cable out of the white connector. You can use tweezers or your fingers.
-
-
-
After removing the power/ volume button board, it should look like this.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.