crwdns2915892:0crwdne2915892:0
If the button board is not responding, use this button board replacement guide. You will need to follow the prerequisite guides before following this guide.
crwdns2942213:0crwdne2942213:0
-
-
Slide the latch towards the center of the laptop so the unlock emblem appears.
-
-
-
Place your finger on the left latch and slide it towards the center of the laptop.
-
-
-
Remove the two 5 mm screws with the Phillips #00 screwdriver.
-
-
-
Using either a credit card or flat spudger, wedge it between the palm rest and the keyboard.
-
-
-
Using the tool of your choice, gently pry up on the top of the keyboard.
-
-
-
Remove the ZIF connector that connects the laptop to the keyboard cable.
-
-
-
-
Using a Phillips #00 screwdriver, remove all the 5 millimeter screws located on the bottom of the laptop.
-
-
-
Using the spudger, remove the two rubber feet that are located near the battery.
-
-
-
Now remove the two Phillips screws that are located below the rubber feet.
-
-
-
Remove the optical drive by pulling it out by hand.
-
-
-
Remove the two Phillips screws inside the optical drive housing.
-
-
-
Disconnect the power button ribbon cable by lifting the connector.
-
-
-
Now disconnect the touch pad ribbon cable by lifting the connector.
-
-
-
Remove the screws indicated by an arrow stamped into the metal.
-
-
-
Insert the spudger between the palmrest and the laptop body.
-
-
-
Lift up on palm rest, while working the spudger around the perimeter.
-
-
-
Release the cable connected to the button board.
-
-
-
Remove the two Phillips screws securing the button board.
-
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Linn Benton Community College, Team S1-G5, Karnes Fall 2018 crwdns2935289:0Linn Benton Community College, Team S1-G5, Karnes Fall 2018crwdne2935289:0
LBCC-KARNES-F18S1G5
crwdns2931471:03crwdne2931471:0
crwdns2935297:05crwdne2935297:0
