crwdns2942213:0crwdne2942213:0
-
-
Insert the plastic opening tool between the digitizer and the case.
-
Place the spudger in the gap created by the plastic opening tool to assist in separation.
-
-
-
Slide the spudger along the perimeter of the device to fully separate the two pieces.
-
-
-
-
Peel off the tape that is attaching the wifi antenna to the case.
-
-
-
Using the soldering iron, heat up the solder that is attaching the antenna to the motheboard.
-
-
crwdns2935267:0crwdne2935267:0Desoldering Pump$3.99
-
Suck up the leftover solder using the desoldering pump.
-
Remove the wifi antenna from the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.