crwdns2915892:0crwdne2915892:0
If your HEC Remote Control stops working properly due to issues like, sticky buttons, a bad LED, or no response from the remote, the use this guide to repair your HEC Remote Control.
The remote control works by sending infrared (IR) signals to communicate with your device. Some symptoms of a faulty IR signal could be buttons not working or corrosion of battery terminals.
Before disassembly, please check for dirt buildup in and on the remote, dead batteries, and battery corrosion. Many signal issues can be resolved by performing a simple cleanup process on the remote.
Finally, remove batteries and disconnect any power source to the remote to prevent further damage.
crwdns2942213:0crwdne2942213:0
-
-
Use a spudger to open HEC Remote Control
-
-
-
Disassemble remote control and remove circuit board
-
Solder LED
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 6-1, Regan Fall 2011 crwdns2935289:0Cal Poly, Team 6-1, Regan Fall 2011crwdne2935289:0
CPSU-REGAN-F11S6G1
crwdns2931471:04crwdne2931471:0
crwdns2935297:06crwdne2935297:0
