H. Preflight Checklist-Sensors

crwdns2944109:0crwdnd2944109:0David Husolocrwdnd2944109:0crwdnd2944109:0crwdnd2944109:0crwdne2944109:0

crwdns2944111:0Huk 5, 2021crwdne2944111:0

crwdns2931273:0crwdne2931273:0

crwdns2937801:0crwdne2937801:0

crwdns2944444:0crwdne2944444:0

crwdns2915892:0crwdne2915892:0

crwdns2942287:0crwdne2942287:0

This guide will help you prepare your printer for it’s first print. It is important to verify the steppers, end stops, and heaters are working correctly before you a attempt to start your first calibration print.

This guide is still a work in progress. Pictures and additional info will be added over the coming weeks

crwdns2931653:01crwdne2931653:0 Sensors

H. Preflight Checklist-Sensors, Sensors: crwdns2935265:01crwdnd2935265:01crwdnd2935265:01crwdne2935265:0

Hotend and bed sensor should be reading around room temperature
If either sensor shows a "-###c"(negative temperature) double check your your connections. It's common to show this if you don't have a good connection.
Vin is your PSU input voltage
V12 is the Duets on board 12v regulator
MCU temperature is the Duets processor temperature