crwdns2915892:0crwdne2915892:0
The display on the Google Pixelbook is secured with strong adhesive and requires some careful prying to separate it from the case. Using heat from a hairdryer, or an iOpener, may help soften the adhesive for easier removal.
crwdns2942213:0crwdne2942213:0
-
-
Use the iFixit opening tools or a metal spudger to pry the rubber covers off the back of your Pixelbook.
-
Peel the linings off completely until the back of the Pixelbook looks bare.
-
-
-
Remove the two yellow 2.0mm screws by using a T3 Torx screwdriver.
-
-
-
Remove the seventeen 3.0mm T5 Torx screws from the bottom panel.
-
-
-
Use the nylon spudger to pry the edge of the Pixelbook up until you can grab the edge with your fingers.
-
Open the back panel completely and lay it flat so you see the whole inside of the computer.
-
-
-
Remove the yellow 2.0mm screw from the middle of the panel by using the T3 Torx screwdriver to turn the screw counterclockwise.
-
-
-
-
Remove the small, black casing by using the spudger to lift it up from its place.
-
-
-
Disconnect the flat, black cord from the main component by using a spudger to push it out of the slot, or by using your hand to carefully pull it out.
-
Your back panel is now free from the main component.
-
-
-
Use an iSclack, or suction cup, to lift up the corner of the display from the case.
-
-
-
Insert an opening pick into the gap between the display and case.
-
Repeat this procedure on other side.
-
-
-
Using an opening pick, slowly pry up on the display until it separates.
-
-
-
Use the pointed end of spudger to flip up the small locking flap on the ZIF connector.
-
Remove the display ribbon cable from the socket.
-
-
-
Use the pointed end of a spudger to flip up the small locking flap on the ZIF connector.
-
Remove the display ribbon cable from the socket.
-
-
-
Flip the display over and lay it flat on the keyboard.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Use a pair of tweezers to grab the clip on the display connector and swing it over to the other side of the socket.
-
Pull on the clip to disconnect the display.
-
Remove the display.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:011crwdne2935229:0
crwdns2947412:09crwdne2947412:0
Where would you find a replacement display?
Any idea on where to get a display replacement for the Pixelbook?
Is it necessary to remove the back in order to remove the screen? I cant see any connection between the two?
Thanks
You remove the back to disconnect the battery.
Sergio B -
any idea how to remove the glass shade on the back panel?