crwdns2942213:0crwdne2942213:0
-
-
Use a spudger, or your fingers, to remove the old back cover adhesive.
-
Use isopropyl alcohol (>90%) and a coffee filter or a microfiber cloth to remove any adhesive residue.
-
-
-
Use tweezers, or your fingers, to remove the three rear camera liners from the inside of your new back cover.
-
-
-
Peel off the remaining clear liners on the outside of the back cover.
-
-
-
Before removing any liners, check if the adhesive matches the frame.
-
-
-
Peel away the top half of the new adhesive strip from its clear liner and keep it folded before continuing.
-
Align the top half of the adhesive over the frame, using the corners as reference points.
-
Place the adhesive on the frame.
-
-
-
Use the flat end of a spudger, or your fingers, to press down the top edge of the adhesive and adhere it to the frame.
-
-
-
-
While peeling away the rest of the clear liner, slowly lay the rest of the adhesive over the perimeter of the phone.
-
-
-
Use the flat end of a spudger, or your fingers, to press down the rest of the adhesive and adhere it to the frame.
-
-
-
Use a spudger to pry up the segmented tab on the bottom right corner of the large blue liner.
-
Lift the tab and peel off the large blue liner to expose the secondary liner.
-
-
-
While holding the back cover or propping it up, reconnect the back cover cable.
-
-
-
Reinsert the top bracket clip under its slot in the logic board and align its screw hole.
-
-
-
Use a Torx Plus 3IP driver to install the 3.0 mm‑long screw securing the top bracket.
-
-
-
Use the tip of a spudger to pry up the segmented tab on the top right corner of the secondary liner.
-
-
-
Peel off the secondary liner to expose the adhesive.
-
-
-
Align the top edge of the back cover with the frame and press down to adhere it.
-
-
-
Press along the perimeter of the back cover to adhere it to the frame.
-
Let the phone sit a few hours for the adhesive to cure.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.