crwdns2942213:0crwdne2942213:0
-
-
Compare your replacement adhesive with your old adhesive. Make sure you have the right adhesive strips.
-
Use tweezers, or your fingers, to remove the old adhesive off the 5G mmWave antenna cable and its spots on the logic board.
-
-
-
Use isopropyl alcohol (>90% or greater) and a coffee filter or lint‑free cloth to remove any adhesive residue.
-
-
-
-
Remove the curved adhesive strip from its opaque liner to expose the adhesive underneath.
-
-
-
Align the curved adhesive strip over the same‑shaped section of the 5G mmWave antenna cable and press it in place.
-
-
-
Repeat the previous two steps for the square‑shaped adhesive strip, placing it over the gold section on the 5G mmWave antenna cable.
-
Remove the colored liners from both of the adhesive strips to expose the adhesive underneath.
-
-
-
Reconnect the 5G mmWave antenna cable.
-
Wrap the cable around its original spot on the logic board and pinch it to re-adhere both sides.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
