crwdns2915892:0crwdne2915892:0
This guide is a pre-requisite step for other Pixel 3a XL guides. It describes the process of removing the midframe between the screen and the rest of the phone’s internals.
crwdns2942213:0crwdne2942213:0
-
crwdns2935267:0crwdne2935267:0Magnetic Project Mat$19.95
-
Remove the following 4.3mm screws:
-
14 silver T3 Torx screws
-
2 black T3 Torx screws
-
-
-
Insert an opening pick into the seam along the bottom of the phone.
-
Slide the pick along the seam to release the clips holding the midframe to the rest of the phone.
-
-
-
-
Slide the opening pick along the left and right edges of the phone to release the midframe clips there.
-
Lift up the bottom edge of the midframe but don’t completely remove it yet. The midframe is still connected to the phone by a fragile cable.
-
-
-
Use a spudger to pry up and detach the proximity sensor cable from the motherboard.
-
-
-
This takes a bit of patience and finesse. Once you have the connector aligned, you can also use a finger to gently press the connector onto the socket.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.