crwdns2869444:0crwdne2869444:0
crwdns2869445:0crwdne2869445:0
crwdns2862633:0crwdne2862633:0
crwdns2862634:0crwdne2862634:0
crwdns2959930:0crwdne2959930:0
crwdns2943213:0crwdne2943213:0
-
GoPro Hero Motherboard$16.99
-
GoPro Hero Screw Set$5.99
crwdns2943215:0crwdne2943215:0
-
-
-
Unclip the black latch to the camera case and open the case.
-
-
-
Gently pry the back open by inserting a metal spudger between the case and back panel.
-
-
-
Disconnect the battery from the motherboard by unplugging the red, white, and black wires from the white adapter.
-
-
-
-
Disconnect the ribbon cable from the lens by lifting the black latch and gently pulling the ribbon cable from the socket.
-
-
-
Use a Phillips screwdriver (PH000) to remove the four screws around the white plastic piece.
-
-
-
Carefully remove the motherboard and white plastic piece from the case.
-
-
-
-
-
Remove the larger ribbon cable from the daughter board by lifting the black latch and pulling the ribbon cable gently from the socket.
-
Disconnect the smaller ribbon cable leading from the white plastic piece by simply pulling it from the socket.
-
-
-
Separate the white plastic piece from the motherboard.
-
-
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0
crwdns2947412:02crwdne2947412:0
So after doing all theses steps did it resolve the problem
Anita - crwdns2934203:0crwdne2934203:0 crwdns2950251:0crwdne2950251:0
Thanks so much I really needed this guide.
Thanks, Sam
Sam Liam Matthews - crwdns2934203:0crwdne2934203:0 crwdns2950251:0crwdne2950251:0