crwdns2915892:0crwdne2915892:0
The fan to computers are used to keep laptops from overheating. This repair guide will cover the steps for to replace a fan to the gateway MD2614u laptop. This guide is perfect for you if you have faulty fan, which can be detected by either a warning on the laptop or if the laptop has constant overheating and slow response time. Ensure that the fan is the problem before proceeding with the guide below. Once you are sure that your fan is faulty and want to install a new fan, please ensure that your laptop is completely powered off and proceed the step by step guide.
crwdns2942213:0crwdne2942213:0
-
-
Place the laptop so the back cover is facing up.
-
-
-
Remove the 8 screws from the back cover using the Phillips #00 screwdriver.
-
-
-
Unplug the fan’s power cable, which is a group of black wires attached to a white plastic head on the motherboard.
-
-
-
Remove the two screws located on opposite sides of the fan with a Phillips #00 screw driver.
-
-
-
The fan is permanently attached to the silver heat sink next to the RAM.
-
To completely remove the parts, loosen the heat sink’s four screws with a Phillips #00 screw driver.
-
-
-
Pull the fan and heat sink toward you at a 20 degree angle upward.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 21-31, Regan Fall 2010 crwdns2935289:0Cal Poly, Team 21-31, Regan Fall 2010crwdne2935289:0
CPSU-REGAN-F10S21G31
crwdns2931471:04crwdne2931471:0
crwdns2935297:014crwdne2935297:0
