crwdns2915892:0crwdne2915892:0
Removing the logic board from the Garmin Nuvi 200
crwdns2942213:0crwdne2942213:0
-
-
Peel off the sticker from the bottom of the device to reveal two screws.
-
-
-
Insert a plastic opening tool in the gap between the front and rear casing.
-
Carefully work the tool around the gap, separating the two halves of the case.
-
-
-
-
Peel away the tape holding the ribbon cable in place.
-
Disconnect the ribbon cable by using a spudger to flip up the retaining flap on its ZIF-style connector. Then gently remove the cable.
-
-
-
Pull out the cable between the logic board and the speaker to disconnect them.
-
-
-
Remove the three screws from the logic board using the #00 Phillips screwdriver.
-
Lift the board away from the case but do not pull the logic board completely off, as it is still attached to the battery by a cable.
-
-
-
Detach the logic board form the battery by pulling out the cable.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0