crwdns2915892:0crwdne2915892:0
Welcome to this replacement guide for the screen of the Garmin Drive 52 and Traffic. The Garmin Drive 52 and Traffic is a GPS navigator that helps you find your way on the road. However, accidents happen and the screen of your device may get damaged or cracked. In such cases, replacing the screen can be a cost-effective solution to get your device back up and running. This guide will walk you through the steps required to replace the screen of your Garmin Drive 52 and Traffic. Please note that this procedure can be a bit tricky and requires some technical expertise.
Before beginning this repair turn off the device.
crwdns2942213:0crwdne2942213:0
-
-
Pop the suction cup off of the device.
-
Unscrew the four T5 Torx screws on the back.
-
Carefully pry apart the front and back with a Jimmy.
-
-
-
-
Pop the screen out of the front casing.
-
-
-
Flip up the ZIF connector's lock bar, remove the ribbon cable, and pull the screen out.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
UMass Dartmouth, Team 1-2, Petersen Fall 2022 crwdns2935289:0UMass Dartmouth, Team 1-2, Petersen Fall 2022crwdne2935289:0
UMASSD-PETERSEN-F22S1G2
crwdns2931471:06crwdne2931471:0
crwdns2935297:04crwdne2935297:0
crwdns2947410:01crwdne2947410:0
Is there some information about the pare part monitor? A possibility where to buy?
