crwdns2915892:0crwdne2915892:0
The repair of the LCD is straight forward. No special skills or knowledge are required.
crwdns2942213:0crwdne2942213:0
-
-
Remove the batteries, hand strap, and memory card if so equipped.
-
Remove the two Phillips screws from the bottom.
-
Remove the two Phillips screws from the left side.
-
-
-
Remove the two screws from the right side.
-
Start splitting the case from the battery compartment to the sides. No special tool is needed to split the case.
-
-
-
-
Do not remove the back side of the case, just flip it over. The speaker is connected by wires to the main body, but positioned in the back case.
-
Flip the LCD to the bottom. You can not yet remove it, because it is still attached to the board.
-
The LCD cable is held into the connector via some compression clips. Move both ends carefully away from the connector, toward the LCD.
-
-
-
After exchanging the LCD for a new one, and after reassembling your camera, you should have a working LCD.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0