crwdns2915892:0crwdne2915892:0
If you need to replace the camera this guide will provide step-by-step instructions on how to disassemble and replace your camera.
crwdns2942213:0crwdne2942213:0
-
-
Remove the white sticker covering the screws (if applicable).
-
Use the PH1 screwdriver to remove the four 2 mm screws from the the backside of the device.
-
-
-
Insert the plastic opening tool along the seam of the back case.
-
Gently slide the plastic opening tool along the entire seam popping the clips free.
-
-
-
Carefully lift the back case and remove the smartcard ribbon from the motherboard.
-
-
-
Remove the ten 3mm screws with a PH00 screwdriver from the shield.
-
-
-
-
Remove the grey docking station port cover.
-
-
-
Gently slide the plastic opening tool along the entire seam popping the clips free.
-
-
-
Lift the shield away from the device and remove the fingerprint scanner's ribbon from the motherboard.
-
-
-
Pull up the cord that connects the battery to the motherboard
-
-
-
Pull the ribbon straight up from the back of the camera board
-
-
-
Remove the single 2mm screw using a PH000 screwdriver from the camera board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.